|Aust. Std Fire Panels are all compatible with FirePro Generators. The Sigma XT panel has a Gas Card to enable delays and warning signs etc. Can operate as a main FIP or Sub FIP and can interface other AS panels.
|Warning Signs are an integral part of the Fire System under Australian Standards. • System Inoperative • Fire Alarm – Evacuate Area • Fire Alarm – Do Not Enter – WP available
|AS 4487-2013 requires a Local Control Station(LCS) if there are multiple entrances to a risk area. The LCS will has a Manual Activation switch and a Mode Switch built in, and indicators for the main panel functions.
|Standards require a system activated advice to be sent to the Fire Panel. A thermal fuse is connected to the FirePro Generators. Connection to the Thermal Fuse is via a Deutsch Plug.
|AS require a monthly test of Systems. This switch allows monthly testing without disruption of connected devices and creates a fault at the panel.
|Alarm management solution for monitoring of fire systems remotely. Configurable using an embedded web server and configuration wizard, it can pass fire system events via e-mail, SMS, Modbus.
|EN54-3 approved electronic LED beacon sounder. Allows 2 levels of alarm (pre-alarm, alarm) controllable via independent contacts. Multitone tones with a strobe flashing light. Suitable for outdoor applications – IP65.
|The board provides a means for additional outputs within the panel status volt free contacts to locations remote from the control panel. The ancillary board is intended only for additional signalling and control purposes.